in this lesson we show you how to connect a LCD display to the Arduino Uno and send text to it.


 Arduino Uno R3  
 LCD display board 16x2 1x  lcdavr 1
jumper wires jumper wires

 arduino lesson 5 schema

 arduino lesson 5 brd


 

/*
Arduino - Lesson 5. LCD display
Demonstrates the use a 16x2 LCD display. The LiquidCrystal
library works with all LCD displays that are compatible with the
Hitachi HD44780 driver. There are many of them out there, and you
can usually tell them by the 16-pin interface.

The circuit:
* LCD RS pin to digital pin 7
* LCD Enable pin to digital pin 8
* LCD D4 pin to digital pin 9
* LCD D5 pin to digital pin 10
* LCD D6 pin to digital pin 11
* LCD D7 pin to digital pin 12
* LCD R/W pin to ground
* LCD VSS pin to ground
* LCD VCC pin to 5V
* 10K resistor:
* ends to +5V and ground
* wiper to LCD VO pin (pin 3)

modified 08 mar 2016
by www.avrprojects.net
*/

// include the library code:
#include <LiquidCrystal.h>

// initialize the library with the numbers of the interface pins
LiquidCrystal lcd(7, 8, 9, 10, 11, 12);

void setup() {
// set up the LCD's number of columns and rows:
lcd.clear();
lcd.begin(16, 2);
// Print a message to the LCD.
lcd.print("Hello World!");
lcd.setCursor(1,1);
lcd.print("Arduino Uno");
}

void loop() {

}