This board is a development board on which you can build your projects. It is suited for educational use, experiments or prototyping. The board uses the ATTiny2313 microcontroller with a 20Mhz clock. The board contains the ISP 10-pin connector for in circuit serial programming. It has also a push button reset switch. It has 15 digital I/O ports with 4 PWM output channels.

  The I/O pins of the microcontroller are also available on two ML10 connectors for connecting for example the LCD-Interface board. The power can be connected via the DC connector which has a pin of 1.1mm. The power regulator supplies the microcontroller with the 5V DC power it needs. The DB9 bus connector can be hooked to the serial port of your PC for communication between the microcontroller and the PC. The MAX232 IC takes care of the voltage conversion of the RS232 voltage levels and the micrcontroller voltage levels.

Technical Details

Microcontroller  ATTiny2313 
Operating Voltage  5VDC
Inut Voltage  9-12VDC
Flash Memory 2kB
EEPROM 0.5 kB
SRAM 0,25kB
Digital I/O pins 15
Dimensions 80 x 50 mm
PC Comminication RS232
Programming AVR-ISP connector
Clock Speed 20Mhz

Schematic and PCB Layout


Programming

The microcontroller on the board can be programmed via the 10-pin ISP connector. The following AT microcontrollers can be programmed with this board:

  • ATTiny2313
  • AT90S2313 (obsolete)
  • AT90S1200 (obsolete)

Connector pinout

In the table below you see the pins of the connectors.

PORTB pin AT2313 pin PORTD pin AT2313 pin ISP pin AT2313 pin
1 PB0 1 PD0 1 PB3
2 PB1 2 PD1 2 NC
3 PB2 3 PD2 3 NC
4 PB3 4 PD3 4 GND
5 PB4 5 PD4 5 RESET
6 PB5 6 PD5 6 GND
7 PB6 7 PD6 7 PB7
8 PB7 8 NC 8 GND
9 GND 9 GND 9 PB6
10 5V 10 5V 10 GND

Software

There are several projects on this site that you can try and use with the ISP-board:


 Part list

1 Bu1 DC Conn 1,1mm pin
2 C1 47µF 16V
3 C2 100nF
4 C3 100nF
5 C4 100nF
6 C5 1µF 63V
7 C6 1µF 63V
8 C7 1µF 63V
9 C8 1µF 63V
10 C9 100nF
11 C10 100nF
12 C11 100nF
13 IC1 7805
14 IC2 AT90S2313
15 IC3 MAX232
16 K1 ML10
17 K2 ML10
18 K3 ML10
19 K4 DB9 female
20 Q1 10MHz
21 R1 10k
22 S1 Switch
23   PCB

 

The ATTiny2313 board can be purchased pre-assembled and tested at www.bizztronix.eu